CompuSTAR 1W900SHR-961 Installationshandbuch PDF herunterladen (Seite 4)

Installation Basics

If you are new to installing Firstech Series Remote Starts and / or Alarms, we highly recommended that

you thoroughly review this manual to installing your first unit.

Key Points to Consider Before Installation:

You must code remotes to this system before anything will function

Program remotes by cycling the ignition ON / OFF five times within seven seconds and tap button 1 (0.5

seconds) on the first remote, and then tap button 1 (0.5 seconds) on the second remote.

RPS-II (Remote Paging Sensor)

All 2 Way units include

an optional RPS that has three main functions; 1. Status LED, 2. Remote

notification when triggered, and 3. Auto unlock/alarm disarm when a user specific 4 digit knock code is

entered via tapping sensor through the windshield.

New Secure Valet

All units in

clude an optional secure valet switch. This switch breaks the internal ignition connection to

prevent the system from being put into valet when cycling the ignition ON / OFF five times.

Internal green loop must be cut for AUTOMATIC transmission vehicles

By default, CM4 and CM5 series units come in

MANUAL transmission mode. You will need to cut the

green loop inside the control module if you are installing the unit in a AUTOMATIC transmission.

Different tach learning procedure

Learn tach b

y: 1. Starting the vehicle with the key, 2. Pressing and holding the foot brake, and 3. Holding

the remote start button on the remote for 2.5 seconds - one chirp and parking light flash indicates that the

vehicle tach signal has been successfully learned. Three chirps indicate that the CM4 or CM5 control

module failed to see a proper tachometer signal. (These units have the option for No Tach / Tachless

and 1.5 second assume cranking).

New Option Menus

The option

menu is larger than the previous CM3 series control modules. It is important to familiarize

yourself with the new options as it will save time in most applications. For instance, Option 1-04 controls

the double pulse unlock feature on all CM4 and CM5 series control modules.

Option Programmer (OP500)

Most options on these u

nits can be programmed with the remote(s), however setting auxiliaries and

Special Option Groups 1 and 2 require the use of the OP500. Please note, the system must be unlocked

/ disarmed to sync the OP500 with the control module. Otherwise, an “ER 01” message will show on the

display of your OP500.

Programmable Output Connectors (POC) Review

wiring diagrams & programming sections

All control modules come with 9 programmable outputs that can be configured 19 different ways. It is

important to familiarize yourself with the POCs as it will save time in most applications.

Internet updatable processors Visit “

Dealer Support” at www.compustar.com

All CM4 and CM5 series units are equipped with some of the most powerful processors available today.

This flexibility allows for on-demand internet updating capabilities in the event of a version update or

change.

1 2 3 4 5 6 7 8 9 ... 35 36

Kommentare zu diesen Handbüchern

Keine Kommentare

CompuSTAR 1W900SHR-961 Installationshandbuch Seite 4

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Fernbedienungen CompuSTAR 1W900SHR-961