CompuSTAR 1W900SHR-961 Installationshandbuch PDF herunterladen (Seite 7)

significant difference in sensitivity for both 1

and 2

stages. Recommended dial settings for most

vehicles is somewhere between 2 & 4.

Siren

(CM4000, CM5000, and CM4300 Only) The volume output of the siren can be increased 3 dB by cutting

black wire loop located near the base of the siren. To adjust duration time when the alarm has been

triggered, change Option 3-07 – the system default is 30 seconds.

Thermistor (Temperature Sensor)

Every 2 Way remote - Firstech system includes an optional thermistor, which must be plugged into the 2

pin port of the control module for use. This plug is white on the CM4000 and blue on the CM5000. The

use of the thermistor allows the 2 Way remote to display the vehicle’s interior temperature on the remote

LCD (liquid crystal display) as well as permitting the vehicle to start with timed Hot or Cold starting; see

options 2-05, 2-07 and 2-08. IMPORTANT: New thermistor plugs are blue 2 pin connectors on the CM5

series but old white plug thermistors will still work.

Hood Pin

The hood pin switch triggers the alarm in the event the hood is opened while the alarm is armed. The

hood pin also doubles as an important safety feature that prevents the remote start from engaging while

the hood is open.

Backup Battery

(CM4000, CM5000, and CM4300 Only) The backup battery input on the control module / brain is for any

optional battery backup unit (sold separately). The red positive lead (+) acts both as an input and

charging output for a 12 Volt battery backup. A backup battery maintains basic alarm functionality when

main vehicle power is lost. See the “Wiring Schematics” section(s) for complete details.

Common Procedures

Jumper Settings

Caution: Jumper settings affect the polarity and use of certain outputs. If these jumpers are used

incorrectly, damage to the vehicle and /or control module may occur.

Jumper 1 (Door Trigger Polarity)

Determines the polarity of the door t

rigger input wire (red/white). In the default position the door trigger

registers negative (-) triggers. To change to a positive (+) trigger, move the jumper.

Jumper 2 (Glow Plug or Key Sense Polarity)

Determines the polarity of the glow plug or key sense input

wire (brown/white). In the default position it

monitors a positive (+) glow plug input. To change to a negative (-) input move the jumper. To change

from the glow plug to the key sense setting, you must change Option 4-09.

Jumper 3 (Parking Light to Trunk Output)

Determines the output type (not pola

rity) of the green/white wire on connector one (CN1). In the default

position it provides a positive (+) parking light output. To change to a positive (+) trunk output move the

jumper. A negative (-) parking light output is found on connector three (CN3) and a negative (-) trunk

output is found on connector four (CN4).

Setting Auxiliary Outputs on Connector 3

1 2 3 4 5 6 7 8 9 10 11 12 ... 35 36

Kommentare zu diesen Handbüchern

Keine Kommentare

CompuSTAR 1W900SHR-961 Installationshandbuch Seite 7

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Fernbedienungen CompuSTAR 1W900SHR-961