9
6. After a few seconds you will hear two relay “clicks” and see two parking light flashes and remote coding
has been completed.
Remote Coding with Secure Valet Switch – Option 3-10, Setting III
To use the Secure Valet Switch you must program Option 3-10, Setting III. The Secure Valet default code is 33.
1. Hold down valet switch for 1.5 seconds. LED on switch will begin to flash rapidly.
2. Tap the button on the switch to enter first number of 2-digit code. LED will flash the first number slowly.
3. Once the LED begins flashing rapidly tap the button on the switch to enter the second number.
4. After the second number is entered the parking lights will flash once
5. Follow step 4 to 5 above.
6. After a few seconds you will hear two relay “clicks” and see two parking light flashes and remote coding
has been completed.
Secure Valet Switch (CN9) Optional
Enables the use of Secure Valet mode, mount where the customer will have easy access. You must program Option 3-
10, Setting III. The Secure Valet default code is 33. Here are the following steps to programming the Secure Valet
code:
1. Turn on Option 3-10-III.
2. Turn key to the ignition on position.
3. Hold down valet switch for 1.5 seconds. LED on switch will begin to
flash rapidly.
4. Tap the button on the switch to enter first number of 2-digit code. LED
will flash the first number slowly.
5. Once the LED begins flashing rapidly tap the button on the switch to
enter the second number.
6. Turn ignition off and Valet Switch is now programmed.
7. To enter valet mode follow steps 3 to 5
LED (CN5) Optional
Bright blue flashing LED used as a theft deterrent, LED output is 3 volts.
Thermistor (CN11)
Senses the current temperature in the vehicle; this item is connected to a port on the back side of the controller.
________________________________________________________________________________________________
T
ACH PROGRAMMING
Once all your connections are made, accessories installed and programmed and remotes programmed you must
program your Tach/Engine Sensing before you can remote start. Unlike the CM3000 and CM4200, the CM4200-DX
does not have a tach learn button. The following procedure shows how to program tach on the new Pro Series.
Tach learning procedure:
(To test for tach sensing set your digital multi-meter for AC voltage.)
1. Start the vehicle with the key. Allow time for the engine to idle down.
2. At idle the tach wire will test between 1 to 4-volts AC. As the R.P.M.’s increase the voltage on the meter will
increase.
3. While vehicle is at idle, hold the foot brake. While holding the foot brake down press and hold the remote start
button down for 2.5 seconds. The parking lights will flash once and siren will chirp once to confirm the control module
accepted the tach signal. If the parking lights flash three times and the siren chirps three times this is confirmation that
the control module did not accept the tach signal. After two seconds the number of parking light flashes will indicate
the cause of the error. The error codes are as follows:
(9 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern