CompuSTAR CM4200DX Installationsanleitung PDF herunterladen (Seite 5)

starter wire will need to be cut. The yellow wire from pin 87a on the starter interrupt relay will go to the

starter side of the vehicles starter wire. The yellow/black wire from pin 30 of the starter interrupt relay

will go to the key side of the vehicles starter wire.)

Pin 7 Green and Red - Ignition output and input. This wire must be connected to the vehicles ignition to power up all

accessories and to trigger remote programming. The proper wire will test 0-volts with the key in the off

position, 12-volts (+) positive while the key is in the on position and 12-volts (+) positive during crank. When

the system is armed and you put (+) 12-volts to the Green wire it will trigger the siren and alarm. (Note: Red

wire is the ignition input and pre-wired to the anti-grind/starter kill relay.)

Pin 8 Black - Ground (-) negative input. This wire will connect to chassis ground.

CONNECTOR 3 (CN3)

* Indicates that the wire is a Programmable Output Connector or P.O.C. Please refer to the Option Program Table –

Special Option Group #2 for programmable options.

Important Note: Before you make all your wire connections and connect the additional items please review the

Option Programming Tables and the descriptions at the end of this manual.

Pin 1 *Green/White

- Parking light 250mA (-) negative output. This is an optional output that will provide a (-)

negative output with parking light flash.

Pin 2 Light Blue - Parking brake (-) negative input. This input is required for manual transmission reservation mode

and/or to trigger the turbo-timer mode. The proper wire will provide a (-) negative trigger only when parking

brake is set. (Note: Turbo mode is optional.)

Pin 3 *Red/Black

- 2nd Starter 250mA (-) negative output. This is an optional output that will provide a (-) negative

output during crank only.

Pin 4 Light Blue/White

- Brake 12-volts (+) positive input. This input is required to shut down vehicle when remote

started. The proper wire will test 12-volts (+) positive only when the foot brake is pressed.

Pin 5 *Green - 2

Ignition 250mA (-) negative output. This is an optional output that will provide a (-) negative

output while the ignition is triggered and during remote start.

Pin 6 Violet/Black

- Trunk-pin (-) negative input. This is an optional input that will monitor when the vehicle’s trunk

has been opened

1 2 3 4 5 6 7 8 9 10 ... 21 22

Keine Kommentare

CompuSTAR CM4200DX Installationsanleitung Seite 5