CompuSTAR CM4200DX Installationsanleitung PDF herunterladen (Seite 7)

trunk release.)

Pin 3 Orange/Black - 2

Unlock 250mA (-) negative output. This wire is an optional output that will provide a (-)

negative pulse output for driver’s priority door lock. (Note: This feature will require additional relays and

programming.)

Pin 4 Blue - Unlock 250mA (-) negative output. This wire will provide a (-) negative pulse output during unlock and

disarm. (Note: Positive and reverse polarity will require additional relays.)

Pin 5 Blue/Black - Lock 250mA (-) negative output. This wire will provide a (-) negative pulse output during lock

and arm. (Note: Positive and reverse polarity will require additional relays.)

Pin 6 Not used

CONNECTOR 5 (CN5) (Pre-wired L.E.D.)

Pin 1 Black - L.E.D.- (-) negative output.

Pin 2 Black/White-3-volt L.E.D. (+) positive output.

CONNECTOR 8 (CN8) (Pre-wired Antenna Cable)

Pin 1 Yellow - RX input. This wire receives signal from remote.

Pin 2 White - TX output. This wire transmits signal to remote.

Pin 3 Red - 12-volt constant (+) positive input.

Pin 4 Black - (-) negative ground input.

CONNECTOR 9 (CN9) (Pre-wired Valet/Programming Switch)

Pin 1 Gray - (-) Negative valet switch input.

Pin 2 Gray - (+) Positive L.E.D. output.

Pin 3 Gray/Black - L.E.D. (-) negative ground input.

CONNECTOR 11 (CN11) (Pre-wired Thermistor)

This connector is for the new Thermistor which monitors temperature in the vehicle.

Pin 1 Thermistor

Pin 2 Thermistor

CONNECTOR 12 (CN12) (RS 232 Port)

This connector will be used for updating the module and connection to various remote start bypass modules. If you are

unsure which version of the Control Module you have then you should reflash with the most current available. The next

section details this new procedure.

________________________________________________________________________________________________

IP SWITCHES

The dip switches on this control module are new for the Pro Series.

Switch 1 sets the polarity of input for the red/white door trigger wire on CN3, Pin 8. In the default position switch 1

should be up and set for negative (-) Door Trigger input.

1 2 3 4 5 6 7 8 9 10 11 12 ... 21 22

Keine Kommentare

CompuSTAR CM4200DX Installationsanleitung Seite 7